P0C3C BMW Fault Code
Check P0C3C OBD Fault Code ReasonThe Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).
The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
P0C3C Code Symptoms :
When you turn on the ignition, the Service Engine Soon or Check Engine P0C3C light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P0C3C!
Diagnosis And Repairing P0C3C
P0C3C OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.
How to fix P0C3C code ?
- Exhaust gas leaks
- Faulty Mass Air Flow (MAF) sensor
- Faulty Crankshaft Position Sensor (POS)
- Faulty oil control valve (OCV)
To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.
Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.
